OUR MODES OF INTELLIGENT AUTO-STANDARD DILUTION | |
Prescriptive Dilution | |
Auto-Standard Prep The SDX can prepare your working calibration standard solutions from the same source stock standard allowing generation of linear calibration lines whilst removing the potential of manual dilution error. Calibration standard solutions are diluted and homogenized immediately prior to analysis. Correlation coefficients of >0.999 are routinely achieved from calibration lines generated via auto-standard preparation. |
|
Prescriptive Dilution Unknown samples can be diluted within the range of 2x to 5000x on a sample per sample basis. Unknown samples can simply be transferred to sample tubes and placed in racks on the ASX-560 autosampler and the dilution factor defined in the ICP instrument operating software. The SDX system will dilute and homogenize sample solutions immediately prior to analysis and removes the need for time-consuming and potentially error prone manual dilutions. |
|
Responsive and Intelligent Dilution | |
Failed Internal Standard Dilution Laboratory quality control protocols demand that the internal standard signal for unknown samples falls within a specific tolerance (± %) with respect to batch blank solutions. The SDX will respond to any samples that fail to meet this requirement, re-diluting them at a greater dilution factor and re-introducing them. This response brings the internal standard of such samples into line. |
|
Exceeding Calibration Range To minimise analytical error, if a sample exhibits an analyte signal greater than that of the top calibration standard then the SDX will respond by re-diluting it at a greater dilution factor and re-introducing it. The new dilution factor is calculated by the ICP instrument operating software to bring any such samples below the concentration of the top calibration standard. |
The AC Analytical Controls Biodiesel All in One analyzer quickly determines the quality of fatty acid methyl esters (FAME) blending stock for diesel fuel, and yields results fast from a single dedicated system.
ULTRA TEC’s bench-top workstation for manual polishing provides a simple, low cost way to ‘get things done’ in the lab. The integral fluid containment tray allows for polishing fluids and abrasives to be collected during the workday and discarded when full, or at the end of a shift.
Water quality analysis is repeatedly performed in laboratories on a daily basis. Horiba LAQUA benchtop models were developed to provide simplicity with excellent on-site usability – from operation and maintenance through to troubleshooting
The NX9000 FIB-SEM system allows the highest precision in material processing for a wide range of areas relating to advanced materials, electronic devices, biological tissues, and a multitude of other applications.
The Quorum Coolstage is a Peltier-cooled cooling stage for scanning electron microscopy (SEM), low vacuum (LV) or variable pressure (VP) applications.
You may contact our specialists by accomplishing form below.
You may contact our specialists by accomplishing form below.